Stick movement reverts to middle or lower value at endpoints

You need flash your Turnigy 9XR with the stock firmware ? So this thread is for you !
Find our last release for the 9XR firmware !!!!

Stick movement reverts to middle or lower value at endpoints

Postby richierich » 22 Oct 2015, 05:58

so i set up my 9xrpro with an orange tx/rx

watching it with my telemetry software, when i push the stick (say the throttle) all the way up, it goes up as it should but once i reach the top it drops back to the lowest point.
anyone know what setting this is? same on all stick axis except other ones revert back to midpoint.

Kind regards

Richie
richierich
 
Posts: 1
Joined: 22 Oct 2015, 05:51

Return to [Official Firmware]

Who is online

Users browsing this forum: No registered users and 1 guest

cron